A normal drone GPS knows where it is to within a meter or two. That is fine for holding position, but not for surveying land, measuring stockpiles or creating accurate maps. For that work, professionals use RTK GPS, which can reach centimeter-level accuracy. In this guide we explain what RTK is, how it works, how it compares with PPK and standard GPS, and when you actually need it for drone mapping.
What is RTK GPS?
RTK stands for Real-Time Kinematic. It is a technique that corrects GPS (and other GNSS) positions in real time using data from a fixed reference station whose position is known very precisely.
Both the reference station (the base) and the drone (the rover) receive signals from the same satellites. Most errors, such as delays in the atmosphere and small errors in satellite orbits and clocks, affect both receivers almost equally. The base station works out these errors and sends corrections to the drone, which removes them from its own position.
How RTK reaches centimeter accuracy
Standard GPS measures the time it takes for a coded signal to travel from each satellite. RTK also measures the carrier phase of the radio wave itself. The carrier wave has a wavelength of about 19 cm on the main GPS band, so measuring its phase allows far more precise distance measurements. Once the receiver solves how many whole wavelengths lie between it and each satellite, accuracy of a few centimeters becomes possible.
RTK receivers report two important states:
- RTK Fixed: the receiver has solved the carrier-phase problem. Accuracy is typically around 1–2 cm horizontally. This is what you want for mapping.
- RTK Float: corrections are being received, but the solution is not fully resolved. Accuracy is better than standard GPS but can be tens of centimeters.
Where do the corrections come from?
- Your own base station: a second RTK receiver placed on a fixed point near the work area, sending corrections to the drone by radio.
- A correction network (NTRIP): a service that sends corrections from permanent reference stations over the internet, usually through the ground station or a mobile connection.
Accuracy decreases slowly with distance from the base station, which is why RTK works best within a few kilometers to a few tens of kilometers of the reference.
RTK vs PPK vs standard GPS
| Method | How it works | Typical accuracy | Main advantage |
|---|---|---|---|
| Standard GPS | Single receiver, no corrections | About 1–3 m | Simple and cheap |
| RTK | Corrections applied in real time | About 1–2 cm (fixed) | Accurate positions immediately |
| PPK (Post-Processed Kinematic) | Raw data from drone and base corrected after the flight | About 1–3 cm | No live radio link needed; can be more robust |
For mapping, both RTK and PPK work well. PPK avoids problems when the correction link drops during flight, while RTK gives accurate positions immediately, which also helps precise navigation and landing.
What hardware do you need?
- A dual-band (multi-frequency) GNSS receiver on the drone. Dual-band receivers such as those based on the u-blox F9P resolve RTK fixes faster and more reliably than single-band ones.
- A correction source: your own base station or an NTRIP service.
- A good antenna mounted with a clear view of the sky, away from interference sources.
- Flight software support. ArduPilot and PX4 both support RTK GPS and can pass corrections from the ground station to the drone.
Note that standard modules such as the M8N and M10 are single-band receivers without RTK capability. See our M10 vs M8N GPS comparison for what they can and cannot do.
Do you still need ground control points?
Ground control points (GCPs) are marked targets on the ground whose positions are surveyed precisely. With RTK or PPK, you need far fewer of them, and sometimes none for relative accuracy. Many surveyors still place a few checkpoints to verify the final map’s accuracy, which is good professional practice.
When do you really need RTK?
- You need RTK or PPK for: land surveys, topographic maps, construction progress measurement, stockpile volumes, and any map that must line up precisely with other survey data.
- You probably do not need it for: general aerial photos, visual inspections, FPV flying, or maps used only for viewing.
Common RTK problems
- Stuck in Float: poor sky view, interference from the drone’s electronics, a weak correction link or the base too far away.
- Wrong base position: if the base station’s own position is wrong, every point on the map is shifted by the same amount.
- Correction link dropouts: check the radio antennas or internet connection, or record raw data so PPK can be used as a backup.
Frequently asked questions
How accurate is RTK GPS on a drone?
With a fixed RTK solution, horizontal accuracy is typically around 1–2 cm and vertical accuracy a little worse, depending on conditions and distance to the base.
Is RTK or PPK better for mapping?
Both can deliver centimeter-level results. PPK is often preferred when the live correction link is unreliable; RTK is convenient because positions are accurate immediately.
Can a normal GPS module become RTK?
No. RTK needs a receiver that measures carrier phase and supports corrections, ideally a dual-band one.
Do I need internet for RTK?
Only if you use an NTRIP network. With your own base station and radio link, no internet is needed.